MDT Premier Scope Ring 34mm Extra High 1.50in
A Premier scope ring from MDT designed for 34mm scope tubes, available in extra high height (1.50in). MDT describes its Lightweight Premier Scope Rings as built with strength in mind while remaining lightweight and easy to install. No lapping is required, and the rings are designed for a precise fit and to hold zero. The Premier range is available for 25.4mm, 30mm, and 34mm tubes, in heights ranging from low (0.820in) to extra high (1.50in).
| Specification | Value |
|---|---|
| Scope Tube Diameter | 34mm |
| Height | 1.50in |
| Design | Lightweight, precise fit, holds zero |
| Installation | No lapping required |
FAQ
What is the height of the MDT Premier Scope Ring for 34mm tubes?
The height is 1.50 inches, which is the extra high option.
Do I need to lap the scope ring when installing it?
No lapping is required. The ring is designed for a precise fit and can be installed directly.
Is this scope ring compatible with other tube sizes?
This ring is specifically designed for 34mm scope tubes. It is not compatible with 25.4mm or 30mm tubes.
Tracey Sanderson –
Installed the ring on my rifle scope without any issues. It fits perfectly and stays secure even during long shooting sessions. No adjustments needed, just snap it into place. The extra high height gives me better alignment with my optics.
Keith Bailey –
Good quality and fits exactly as described. The ring is lightweight and doesn’t add much bulk. I appreciate that no lapping is needed, which saved me time during setup.
Jason Russell –
Perfect match for my 34mm scope. The height is exactly what I needed for a clear sight picture. It holds zero well and feels solid during use.